USER'S MANUAL. PROLINK-4
4.9.4.8
Measurement Units
The PROLINK-4 offers three measurement units to measure level and channel
power: dBµV, dBmV and dBm.
To select the units of measurement, access the TV mode functions menu, turn
the rotary selector [4] to select the Units function and press to activate it. The monitor
will show a screen labelled UNITS displaying the three available options (as well as the
Exit option). Turn the rotary selector [4] to the units you require, then press to activate it.
4.9.4.9
Power Off Mode (Manual power)
The PROLINK-4 offers two power-off modes: Manual and Automatic (unit
disconnects automatically after 15 minutes without operating on any control).
To select the power-off mode, access the TV mode functions menu, turn the
rotary selector [4] to select the Manual power function and press to activate it. The
monitor will show a screen labelled POWER OFF displaying the two available options
(as well as the Exit option). Turn the rotary selector [4] to select the power-off mode you
require, then press to activate it.
4.9.4.10
C/N setup
To measure C/N the PROLINK-4 offers two different modes in TV mode:
C/N (Auto)
C/N (Reference noise)
To select C/N mode, access the TV mode functions menu, turn the rotary
selector [4] to the C/N setup function and press to activate it. The monitor will show a
screen labelled C/N SETUP displaying the two available options (as well as the Exit
option). Turn the rotary selector [4] to the mode you require, then press to activate it.
4.9.4.11
Channel Bandwidth (Channel BW)
To measure the power and C/N ratio of digital channels, as well as the C/N ratio
of satellite band channels, you first need to define the channel bandwidth.
02/2003
The PROLINK-4 defines automatically the frequency
where noise level is measured, according with:
f noise = f tuning - ½ Channel BW.
The user defines the frequency where noise level is
measured (by means of the Reference noise
function). This frequency will be used to measure
noise level for all channels.
Page 67