Hitachi Koki C 12LSH Instrucciones De Seguridad Y Manual De Instrucciones página 23

Marking
(pre-marked)
NOTE:
Check and make sure on a periodic basis if the position of the laser line is in
order. As regards the checking method, draw a right-angle ink line on the
workpiece with the height of about 25/32" (20 mm) and the width of 5-29/
32"(150 mm), and check that the laser line is in line with the ink line [The
deviation between the ink line and the laser line should be less than the ink
line width (0.5 mm)]. (Fig. 20)
11. DIGITAL DISPLAY PANEL (for C12LSH)
Miter angle window
(Displays arrows show angle and
direction that turntable is rotating.
Left is ← Right is →.)
Miter angle reset button
Digital display switch
(for C12LSH)
(Also serves as laser marker
power switch.)
Laser line
Fig. 20
Laser marker switch
Fig. 22-a
(3) After adjusting the position of the laser
line, draw a right-angle ink line on the
workpiece and align the ink line with the
laser line. When aligning the ink line,
slide the workpiece little by little and
secure it by vise at a position where the
laser line overlaps with the ink line. Work
on the grooving again and check the
position of the laser line. If you wish to
change the laser line's position, make
adjustments again following the steps
from (1) to (3).
Back light ON/OFF switch (Press and the
switch illuminates. Press again and the
lighting turns off.)
Fig. 21
(1) Turning on the digital display switch
shows 0° for both miter and bevel angle,
regardless of main unit angle.
(2) Align the main unit angle with the tilt
angle (0°) and miter angle (0°) and hold
down their reset buttons for at least 0.2
second.
(3) Turning on the laser marker switch while
the digital display switch is on, lights up
the laser marker. (On the C12RSH, only
the laser marker switch.)
Bevel angle window
(Displays arrows showing motor
head bevel angle and bevel
direction. Left is ← Right is →.)
Bevel angle reset button
English
23