Replacement Parts; Use Proper Extension Cord - Hitachi Koki C 12LSH Instrucciones De Seguridad Y Manual De Instrucciones

Tronzadora radial abatible
Ocultar thumbs Ver también para C 12LSH:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
7.
Always disconnect power before changing blade or servicing.
8.
Saw blade diameter is 12" (305 mm).
9.
No load speed is 3,800/min.
10. To reduce the risk of injury, return carriage to the full rear position after each crosscut
operation.

REPLACEMENT PARTS

When servicing use only identical replacement parts.
Repairs should be conducted only by a Hitachi authorized service center.

USE PROPER EXTENSION CORD

Make sure your extension cord is in good condition. When using an extension cord, be
sure to use one heavy enough to carry the current your product will draw. An undersized
cord will cause a drop in line voltage resulting in loss of power and overheating. Table
shows the correct size to use depending on cord length and nameplate ampere rating. If in
doubt, use the next heavier gage. The smaller the gage number, the heavier the cord.
Ampere
Rating
More
Not More
Than
Than
0 – 6
6 – 10
10 – 12
12 – 16
WARNING:
Avoid electrical shock hazard. Never use this tool with a damaged or
frayed electrical cord or extension cord.
Inspect all electrical cords regularly. Never use in or near water or in any
environment where electric shock is possible.
8
MINIMUM GAGE FOR CORD SETS
Total Length of Cord in Feet (Meter)
0 – 25
26 – 50
(0 – 7.6)
(7.9 – 15.2)
18
18
16
14
51 – 100
(15.5 – 30.5)
AWG
16
16
16
12
Not Recommended
101 – 150
(30.8 – 45.7)
16
14
14
12
14
12

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

C 12rsh

Tabla de contenido