Hitachi Koki C 12LSH Instrucciones De Seguridad Y Manual De Instrucciones página 26

Tronzadora radial abatible
Ocultar thumbs Ver también para C 12LSH:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
2. Using the Vise Assembly (Standard accessory)
6mm wing
bolt (B)
Fence
Vise shaft
6mm wing bolt (A)
WARNING:
CAUTION:
3. Cutting Operation
a
b
a
b
Marking
Marking
(pre-marked)
(pre-marked)
(Front view)
(3) Once the saw blade contacts the workpiece, push the handle down gradually to cut
into the workpiece.
(4) After cutting the workpiece to the desired depth, turn the power tool OFF and let
the saw blade stop completely before raising the handle from the workpiece to
return it to the full retract position.
26
Screw holder
Knob
Vise plate
Workpiece
Fig. 25
Always firmly clamp or vise to secure the workpiece to the fence;
otherwise the workpiece might be thrust from the table and cause
bodily harm.
Always confirm that the motor head (see Fig. 1) does not contact
the vise assembly when it is lowered for cutting. If there is any danger
that it may do so, loosen the 6 mm wing bolt (B) and move the vise
assembly to a position where it will not contact the saw blade.
Adjusting line
a
Fig. 26
(1) The vise assembly can be mounted on
either the left fence {Fence (B)} or the
right fence {Fence (A)} by loosening the
6mm wing bolt (A).
(2) The screw holder can be raised or
lowered according to the height of the
workpiece by loosening the 6mm wing
bolt (B). After the adjustment, firmly
tighten the 6mm wing bolt (B) and fix
the screw holder.
(3) Turn the upper knob and securely fix the
workpiece in position (Fig. 25).
(1) As shown in Fig. 26 the width of the
b
saw blade is the width of the cut.
Therefore, slide the workpiece to the
right (viewed from the operator's
position) when length b is desired,
or to the left when length a is
desired.
If a laser marker is used, align the
laser line with the left side of the
saw blade, and then align the ink
line with the laser line.
(2) Once the saw blade reaches
maximum speed, push the handle
down carefully until the saw blade
approaches the workpiece.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

C 12rsh

Tabla de contenido