Hitachi Koki C 12LSH Instrucciones De Seguridad Y Manual De Instrucciones página 6

English
DO's
ALWAYS OBSERVE THE FOLLOWING RULES TO ASSURE SAFE USE OF THIS
TOOL:
1. Review this Manual and familiarize yourself with the safety rules and operating
instructions for this POWER TOOL before attempting to use it.
2. Always confirm that the POWER TOOL is clean before using it.
3. Always wear snug-fitting clothing, non-skid footwear (preferably with steel toes) and
eye protection when operating the POWER TOOL.
4. Always handle the POWER TOOL carefully. If the POWER TOOL falls or strikes against
a hard object, it might become deformed or cracked or sustain other damage.
5. Always cease operating the saw at once, if you notice any abnormality whatsoever.
6. Always confirm that all components are mounted properly and securely before using
the tool.
7. When replacing the saw blade, always confirm that the rpm rating of the new blade is
correct for use on this tool.
8. Always shut off the power and wait for the saw blade to completely stop rotating before
doing any maintenance or adjustments.
9. During slide cutting, always push the saw blade away from the operator.
10. Always clamp or otherwise secure the workpiece to the fence; otherwise the workpiece
might be thrust form the table and cause bodily harm.
11. During miter or bevel cutting, always wait for the rotation of the blade to stop completely
before lifting the saw blade.
12. Always make a trial run first before attempting any new use of the saw.
13. Always handle the saw blade with care when dismounting and mounting it.
14. Always confirm that the workpiece is free of nails or other foreign objects before
beginning a cut.
15. Always keep your hands out of the path of the saw blade.
16. Always confirm that the lower guard is in the proper place before using the saw.
17. Always confirm that the lower guard does not obstruct the sliding motion of the saw
before attempting slide cutting.
18. Inspect the tool power cords periodically.
19. Always confirm that the proper lengths and types of extension cords are being utilized,
if necessary, before starting the tool.
20. Always confirm that the motor air vents are fully open before using the tool.
21. Always wait until the motor has reached full speed before starting a cut.
22. Always keep the handles dry, clean and free of oil and grease. Hold the tool firmly
when in use.
23. Always use outboard stands to provide support for long workpieces that overhang the
table of the slide compound miter saw.
24. Always operate the tool after ensuring the workpiece is fixed properly with a vise
assembly.
25. The operating instructions provided with the tool shall direct the user to secure the tool
to supporting structure if, during normal operation, there is a tendency for the tool to
tip over, slide, or walk on the supporting surface.
6