Makita RBC220 Manual De Instrucciones Original página 10

[es]
Assembling of engine and drive shaft
10
CAUTION:
Before doing any work on the brush cutter or the grass trimmer,
always switch off the motor and pull the spark plug connector off
the spark plug. Always wear protective gloves!
CAUTION:
Start the brush cutter or the grass trimmer only after having
assembled it completly.
For machines with Loop handle
e Insert the nuts MS (1) into the hex holes in the holder case. Insert
the screws MS x 30 (2) through the opposite holes and semi-tighten
the screws M5 x 30.
+ Insert the shaft into the holder case fully untill the grip end reaches
the holder case while passing the throttle wire and the switch cords
(4) through the slot in the holder case.
NOTE:
Match the square drive of the inner shaft to the square hole inside
the holder case by slightly rotating the drive shaft or the support
washer on the head case, and you can insert the drive shaft into
the holder case smoothly.
Be cautions not to allow the switch cords to be pinched between
the holder case and the grip end.
e Match the hole in the holder case to the hole in the inner shaft
and insert the screw M5 x 8 through the holes. Then tighten the
screw M65 x 8 and the screws M5 x 30 (5).
NOTE:
Squeeze the throttle lever to make sure that the throttle wire moves
smoothly.
*Connect the switch cords to the two cords from the engine by
inserting one into the other. Insert them through the holes in the
cover (6).