Makita RBC220 Manual De Instrucciones Original página 12

12
For machines with Loop handle (CEN)
e Loosen the screws M5 X18 and insert the drive shaft into the holder
case.
(Note)
Always insert the drive shaft into the holder case fully (approx.
63 mm; 2-1/2"). If the inner shaft resists full insertion of the drive
shaft, try to insert it again after slightly rotating the drive shaft or
the support washer on the gear case to match the inner shaft to
the hole inside the holder case.
e After making sure that the drive shaft is installed fully and properly.
tighten the screws M5 X18 to secure the drive shaft.
e Remove the air cleaner cover from the carburetor.
e insert throttle wire (1) through adjusting screw (2) and fit the nip-
ple of the throttle wire into swivel (3) of the carburetor.
e Adjust the adjusting screw to take up free play of the throttle wire
ensuring the throttle is fully opened when the throttle lever is in
high speed position and 2 — 3 mm (0.079" — 0.118") free play
when in low speed position.
e Connect the female and male bullet connectors from the
throttle assembly to the male and female bullet connectors
coming from engine.
e Retouch the air cleaner cover.
e Insert the bullet connectors (10) through the holes in the cover (11).
e Fix the earth code in the holder case with the attached wire clamp.
e Take care that the connector does not come off.