Breguet 3880 Instrucciones De Uso página 9

3880
"T XXII"
YPE CHRONOGRAPH
,
DATE AUTOMATIC REWINDING
The crown has four positions:
1. Screwed in
2. Manual rewinding
3. Correction of time zone and
date
4. Time-setting (reference time)
Starting the watch
Unscrew the crown by turning it anti-
clockwise (M) until it reaches position
2. In this position the automatic move-
ment can be rewound manually by turning
, 10H
Z FREQUENCY
, -
WATER RESISTANT TO
the crown clockwise ( ). When the watch
has been stopped or has reached the end
of the power reserve, make 30-35 full
turns of the crown to give sufficient energy
to the mechanism and allow the automatic
system to complete the rewinding. Once
this has been done, set the time as
explained in the paragraph below. Then
screw in the crown by turning it clock-
wise ( ). When the watch is on the wrist,
the movement is rewound automatically.
Off the wrist, after being fully rewound it
will run for approximately 40 hours.
, ,
FLYBACK DOUBLE TIME ZONE
10 (100
BAR
Setting the time and indexing the time
zone
Unscrew the crown by turning it anti-
clockwise (M), then pull it out to posi-
tion 4. Turn the crown clockwise ( ) to
advance the minute hand, the HR hand
and the H24 hand to the required time
(reference time). To set the time precisely,
the hands must be adjusted by advancing
clockwise. Then push the crown back to
position 2.
Pull the crown out to position 3 and
change the hour hand of the central time
zone HF, activating the date change (morn-
ing or evening), until the local time is
,
)
M