Publicidad
Idiomas disponibles
Idiomas disponibles
■
Never press on the spindle locking button
while the grinding disc
♦
Switch the appliance on by pressing the
ON/OFF switch
♦
Set a speed suitable for the work using the
speed control
.
♦
Switch the appliance off by pressing the
ON/OFF switch
Fitting the polishing mandrel
WARNING! RISK OF INJURY!
►
Always remove the power plug from the
wall socket before carrying out any work
on the appliance.
■
WARNING! Never use grinding discs
on the brush side of the machine!
CAUTION!
♦
Never press on the spindle locking button
while the grinding disc
♦
Remove the cap
♦
Press the spindle locking button
shaft.
♦
Screw in the polishing mandrel
♦
Screw the desired polishing tool
or
onto the polishing mandrel
4g
♦
Completely cover the grinding disc
the protective cover
♦
After finishing work, remove the polishing man-
drel
by working in the reverse order.
NOTE
►
Do not apply any lateral pressure to the brushes.
PMDS 100 B1
,
is turning
4a
4b
.
again.
,
is turning.
4a
4b
.
to block the
(see fig. B).
,
,
4c
4d
4e
(see fig. B).
,
4a
4b
(see fig. B).
Replacing the grinding disc
WARNING! RISK OF INJURY!
►
Always remove the power plug from the
wall socket before carrying out any work
on the appliance.
WARNING!
►
The grinding disc
any larger than the prescribed diameter.
♦
Unscrew the fixing screw
and remove the cover (see fig . C).
♦
Never press on the spindle locking button
while the grinding disc
♦
Press the spindle locking button
shaft.
♦
Unscrew the union nut
using a monkey wrench.
♦
Take the tension disc
disc
,
4a
4b
fig. C).
♦
Place a new grinding disc on the centring flange
and push this onto the shaft
♦
Screw the tension disc
back onto the shaft
♦
Keep the spindle locking button
,
4f
and re-tighten the union nut
using
WARNING! RISK OF INJURY!
►
Never use a grinding disc
protective cover.
♦
Replace all side covers and fasten them securely
in place by tightening the fixing screws
■
,
used may not be
4a
4b
on the side cover
,
is turning.
4a
4b
from the appliance
, union nut
and the centring flange
and the union nut
.
.
,
4a
4b
Direction of rotation of the tool!
GB │ IE
to block the
, grinding
off (see
(see fig. C).
pressed in
without the
firmly.
│
17
■
Publicidad
