4. Getting started
4.1 Cleaning before first use
It is important to do the following before using your breast pump for the
first time:
1. Disassemble and clean all parts (except for the tubing) according to
the instructions –see chapter 5 and 6.
2. Please ensure to boil all parts of the collection cup before first use.
Do not clean or boil the tubing.
3. When assembling, please ensure the cup is fully sealed until you
hear a snap - see chapter 7.2.
WARNING
Only use power adapter and cable that comes with the breast pump.
An inadequate power source or cable may result in a fire hazard,
electric shock or malfunction equipment due to overvoltage. Do not
expose the breast pump or battery to excessive temperature.
5. Disassembling your collection cup
Refer to figure ¢3 on the foldout pages.
1. ¢3-01 Open the collection cup using the tabs (3-01-1) at the bottom.
2. ¢3-02 Remove the yellow membrane from the breast shield.
6. Cleaning
It is important you do the following before using your collection cup parts for
the first time: Disassemble all parts and clean by following the cleaning
instructions.
Supplies needed:
• Dish soap
• Clean soft brush
• Clean wash basin or dishwasher
• Drinking-quality water
• Clean pot for boiling water
Parts to wash or sanitise:
• Breast shield
• Outer shell
• Yellow membrane
4.2 Charging the battery
Charge the battery for two hours. Refer to figure ¢2 on the foldout
pages.
1. ¢2-01 Connect the power cable to the motor unit.
2. ¢2-02 Connect the power cable to the power adapter.
3. ¢2-03 Plug the power adapter into a wall outlet.
Æ During charging, the status light is pulsing in green color.
Æ When charging is complete, it lights up steadily in green color.
For details on the status light see chapter 8.2.
Information
• The warranty is only valid when using the Medela power adapter to
charge your pump (Model MS-V2000U050-010B0-*).
• You can use the breast pump while charging the battery. However, it
will charge in a slower mode when the pump is running.
*country code
CAUTION
Separate and wash all parts that are in contact with breast milk
immediately after use. This will help to remove breast milk residue
and prevent growth of bacteria.
• Wash hands thoroughly with soap and water.
• Only use drinking-quality tap water or bottled water for cleaning.
• Do not place collection cup parts parts directly in the sink to rinse
or wash. Use a clean wash basin used only for infant items.
• Do not use a dish towel to rub or pat items dry.
• Do not use disinfectants for cleaning.
7