GE PT920 Manual Del Propietário página 42

Before you call for service..,
Troubleshooting tips
Save time and money! Reviewthe charts on the following
pages first and you may not need to carl for service,
Possible Causes What To Do
Control signals after You forgot to enter a bake * Touch BAKE and deshed temperature or
entering cooking time temperature or cleaning SELF CLEAN and desired clean dine.
or delay start time.
Food does not bake Oven controls improperly set. = See the Using the oven secdon.
or roast preperly
Rack position is incorrect • See the Using the oven secdon
or the rack is not level.
Oven floor not in place. • Replace the oven floor
Oven thermostat needs * See the Adjust the Oven Thermostat--Do It Yourself!
adjustment, section.
Food does not
Oven door is open. + (;lose the doo_: This model is designed for closed door
broil properly
broiling only. Always broil with the door closed.
Oven controls improperly set. • Make sure you touch BROIL.
Improper rack position
+ See the Broiling Guide.
being used.
Food being cooked + For best results, use a pan designed fbr broiling.
in a hot pan. Make sure it is cool.
Cookware not suited
+ For best results, use a pan designed
fin broiling.
for broiling.
The probe is plugged into the • Unplug and remove the probe fiom the oven.
outlet in the oven.
In some areas the power + Preheat the broil element fin 10 minutes.
(voltage) may be low.
+ Broil fin the longest period of time recommended in
the Broiling Guide.
Clockand timer
A fuse in your home may be + Replace die fuse or reset die circuit breaker:
dO nOt work
blown or the circuit breaker
tripped.
Oven controls improperly set.
+ See the TOSet the Clock and Kitchen timer and control
lockout sections.
Oven light does
light bulb is loose or defective.
+ Tighten or replace
the bulb.
not work
The oven is self-cleaning or ® The oven lights do not come on during self=cleaning
the Sabbath option is set. or if the Sabbath option is set.
Pad operating light is broken. * Call fbr service.
Extension rack is noisy
The rack was cleaned in the
+ See Extension Rack in the Care and cleaning section.
and/or difficult to slide self-clean cycle and now
needs to be lubricated. + Do not spray with cooldng spray or other lubricant
sprays.
Bearings have become + Install the rack in the oven (see
Extension Rack
in
misaligned due to handling, the
Using the
oven section) and pull firmly on the
sliding portion until it reaches full extension. This
will reset the bearings to their proper position.
Release levers on The rack was cleaned in the + Shake and apply the graphite lubrication, shipped
extension rack become
self-clean cycle, or the original with your oven,
onto the moving
parts of the release
difficult
to use lubrication was removed by levers and paddle mechanisms. Do not spray with
cleaning, cooking spray or other lubricant sprays.
Oven temperature too
hot or too cold
42
Oven thermostat
needs adjustment.
+ See the Adjust the Oven Thermostat--Do It Yourselfi
section.