Pan Placement - GE PT920 Manual Del Propietário

Using theoven.
Aluminum foil
Donot usealuminum foil on thebottomof the oven.
Nexvr entirely (:o_vr a tack with ahmfinum
fbiL This will disturb the heat circuladon and
result in poor baking. A smaller sheet of foil
may be used to catch a spillover by placing it
on a lower rock several inches below the fbod.
Pan Placement
For ex_n cooking and proper bro_Mng, there
must be enough room for air circulation in
the oxen. Baking results will be better if
baking pans are centered as much as possible
rather than being placed to the front or to
the back of the o_pn.
Pans should not touch each other or the _alls
of the o_n. Allow 1" to 1 _" space bet_xven
pans as _x_llas bemven pans and oxen _x_dls.
NOTE" F orconvection bakingof cookies, s ee
the Multi-Rack Convection B akingsection.
Baking Pan/Sheets
Use the proper baking pan. The b,pe of
finish on the pan determines the amount
of browning that will OCCUL
* Shinb bright and smooth pans reflect
heat, resulting in a lighm_,more deficam
bro,_Mng. Cakes and cookies require this
b,pe of pan or sheet.
* Dark, rough or dull pans absorb beat
resulting in a browne_; crisper crust.
Use this b,pe fbr pies.
* (glassbaking (fishes also absorb beat.
_]aen baking in glass baking dishes, the
tempecature m W need to be reduced
by 25°E
Preheating
Mlow the ox>n to preheat before placing food
in the o_en.Preheatingis necessary f or good
results when baking cakes, cookies, pastU and
breads.
To preheat,set theovenat the correct t emperature.
The convection fan wi// turnonduringpreheating. T he
control w i// signalwhenthe ovenis preheated--this
wi// takeapproximately lOminutes.The screenwi//
showtheset temperature.
When thecontrol signals, foods should b eplaced in
theoven.
Oven Airflow
An internal cooling tim opecates during all
oven modes. The warm air flom inside the
oven will be exhausted out through vents
located at the bottom of the oven doo_:
Intake air will be pulled into the oven
through vents located between the door
and the control panel.
Do not allow this airflow to be obstruc/ed
by blocking the vents at the bottom of the
(toot; or at the top of the door by (Imping
ki/chen to,x_ls oxer the flont of the o_n
in undercounmr applications.
8