Thermador PRG36 Manual De Instalación página 22

Backguard Installation
AVAILABLE FOR THESE PRO GRAND ® GAS MODELS:
PRG366JG Pro Grand 36" Gas Range 6 Burner
PRL366JG Pro Grand 36" Gas Range 6 Burner - LP
PRG364JDG Pro Grand 36" Gas Range 4 Burner Griddle
PRL364JDG Pro Grand 36" Gas Range 4 Burner Griddle - LP
PRG486JDG Pro Grand 48" Gas Range 6 Burner Griddle
PRL486JDG Pro Grand 48" Gas Range 6 Burner Griddle - LP
NOTE: If a backsplash is to be used in addition to a
backguard, install the backsplash first and the backguard
second before sliding range into place.
(1) High Shelf top panel
(1) High Shelf front panel
,_-_,x_;_;_:,_. ( 13) T-20 Torx Stainless screws
U'* ........ (16 or 14) T-20 Torx drill point screws
(1) Installation Guide
Low Back Parts Included
(1) Low Back panel
or T-20 Torx stainless screws
i_o,_,_o_,,,/j_,_,_ `" o..... (9(8 o r 8)6) T-20 Torx drill point screws
(1) Installation Guide
Tools Needed
T-20 Torx head screwdriver or drill
Protective Work Gloves
WARNING
To reduce the risk of fire or injury to persons, check to
make sure all packaging has been removed from
accessory devices before use.
WARNING:
Fingers or hands could get pinched when installing the
backguard. Severe injury could result. Use extreme
caution and wear thick protective gloves to avoid
potential laceration to finger or hand while sliding the
backguard down onto the range.
CAUTION
The High Shelf can get very hot! DO NOT place the
following items on top of the High Shelf:
• plastics or containers that can melt
• flammable items.
• a total load over 30 pounds (13.6kg)
High Shelf
FIGURE19:
HIGH SHELF & LOW BACK FRONT VIEW
English 20