Thermador PRG36 Manual De Instalación página 8

36" (914mm) Min.
to combustible
materials
]
36 3A" Max (933mm)
35 _" Min
/
/
/
1911mm)//
/
I
I
I
I
p_
31¼" (794mm)
_91_29 ½" (740mn023A,,
(70r_.,
High Shelf
J
Low Backguard
,q-- 25½" (638mm)_
maximum
recess depth
;_ 26 _" (683mm)
48 3A" (1238mm)
211/8" (537mm)
WallA
as defined in the "National Fuel Gas
"_ode" (ANSI Z223.1, Current Edition).
"_learances from non-combustible materi-
als are not part of the ANSI Z21.1 scope
_nd are not certified by CSA. Clearances
)f less than 12" (305 mm) must be
_pproved by the local codes and/or by the
ocal authority ha ving jurisdiction.
FIGURE 2: INSTALLATION CLEARANCES WITH HIGH SHELF OR
Low
BACKGUARD
/_ as defined in the "National
=uel Gas Code" (ANSI Z223.1,
"_urrent Edition). Clearances
°tom non-combustible materials
_re not part of the ANSI Z21.1
_cope and are not certified by
"_SA. Clearances of less than
12" (305 mm) must be
_pproved by the local codes
_nd/or by the local authority
'_aving jurisdiction.
T
36" (914mm) min
to combustible
materials
T
36 3A" Max (933mm)
35 _" Min (911 mm)
12" (305mm) min /
to combustible A
surface with Flush ,
Island Trim
Flush Island Trim
Materials
Note: For Flush Island
Trim installations,
counter surface should
have a cantilever edge
meeting the back section
of the Flush Island Trim
accessory.
Cantilever
If an inner wall is
used under the cantilever
counter top, there should
be a 118" (3mm) gap from
the rear of the range to the
inner wall.
FIGURE 3: INSTALLATION CLEARANCES WITH INCLUDED FLUSH ISLAND TRIM
English 6