Publicidad
Idiomas disponibles
Idiomas disponibles
11. INSTALLING THE FLAME BROILER COMPONENTS
Parts Required:
1
x
Flame Broiler Slider (#6)
1
x
Flame Broiler Main Plate (#7)
1
x
Flame Broiler Adjusting Bar Handle (#5)
1
x
Flame Broiler Adjusting Bar (#4)
Installation:
•
Insert the Flame Broiler Main Plate into the Main Grill, right side first.
Rest the Flame Broiler Main Plate on the built-in ledge (on the inside
right) of the Main Grill that directs grease towards the grease bucket.
Slide the entire piece to the left side, and the two slots on the Flame
Broiler Main Plate will fit into the rounded ledge above the fire pot. It
will sit slightly at a downward angle. Note 11A.
IMPORTANT: If the Flame Broiler Main Plate is on the base of the
barrel, it is installed incorrectly. The Flame Broiler Main Plate should
sit at an angle, with the left side sitting higher than the right. Poor
installation of this part may result in damage to your Main Grill
barrel.
•
Place the Flame Broiler Slider on top of the Flame Broiler Main Plate,
covering the slotted openings. Ensure the raised tab is on the left,
to easily adjust for direct or indirect flame when cooking. Note
illustration 11B. Both Flame Broiler parts are lightly coated with oil to
avoid rusting when shipped.
•
Next, remove the Flame Broiler Adjusting Bar Handle from the Flame
Broiler Adjusting Bar. Insert the Flame Broiler Adjusting Bar through
the opening hole on the left side of the Main Barrel. Add the Flame
Broiler Adjusting Bar Handle back onto the end outside the barrel.
Next, slide the notched end of the Adjusting Bar into the locking tab
on the Flame Broiler Slider, giving you adjustable access to the Flame
Broiler Slider on the main plate. Note steps in 11C.
NOTE: When the Flame Broiler Slider is open and direct flame is used,
do not leave the grill unattended for any period of time.
Insert the flame broiler adjusting bar
Insert the flame broiler adjusting bar
11A
11B
6
11C
4
5
B
7
7
11
Publicidad
