Publicidad
Idiomas disponibles
Idiomas disponibles
The Controller Knob is used to increase, decrease, and select a setting value. Rotate the Controller Knob
to select the time, temperature, or step in an active setting menu. Push the Controller Knob to confirm
the chosen value.
The central readout displays both the Actual and Set temperatures. The Actual temperature is constantly
displayed unless the Set temperature is being adjusted. The Actual temperature is the temperature
from inside the Main Barrel. The Actual temperature readout is taken by the grill probe (sensor) from
the inside of the grill barrel.
To show the Set temperature, press the Controller Knob. The Set temperature is active when the readout
is blinking. To adjust the Set temperature, rotate the Controller Knob, as needed. Once the desired Set
temperature is reached, press the Controller Knob to confirm the Set temperature, then the readout will
return back to the Actual Temperature.
Press SMOKE MODE until it flashes to enter Smoke Mode. Press the "P" Set button in the smoke position
(S on the display), the temperature display will flash to display the P value. The knob can be used to
adjust P0-P7. Press the SMOKE MODE button again to cancel the Smoke Mode.
Press and hold to switch the temperature unit between °F/°C.
Displays the current Recipe Step.
Displays the Time set during the Recipe Step. Press the Recipe Button to activate the Recipe settings.
Use the Controller Knob to switch through the Recipe Steps, one being the Time.
Displays the Actual and Set temperature of the Programmable Meat Probe - which is the first Meat
Probe plug-in port (MPC). The Actual temperature is constantly displayed unless the Set temperature
is being adjusted. When the MPC Button is pressed, the selected Meat Probe readout will blink and the
Set temperature can be adjusted. When not in use, disconnect the Meat Probe from the connection port
and code "noP" will be displayed. Compatible with Pit Boss® Grills branded meat probes only.
Displays the Actual temperature of a Meat Probe. These three Meat Probe readouts correspond with
the plug-in connection port selected. When not in use, disconnect the Meat Probe from the connection
port and code "noP" will be displayed. Compatible with Pit Boss® Grills branded meat probes only.
The FAN icon is visible when the fan is in operation. When the central readout has an error code (Err)
and the FAN icon is blinking, the Fan is not working. See the section on troubleshooting for assistance.
The AUGER icon is visible when the auger is turning. When the central readout has an error code (Err) and
the AUGER icon is blinking, the auger is not working. See the section on troubleshooting for assistance.
The IGNITOR icon is visible when the ignitor is in use. When the central readout has an error code (Err)
and the IGNITOR icon is blinking, the ignitor is not working. See the section on troubleshooting for
assistance.
When the central readout has an error code (Err) and the PELLET icon is visible, the fire in the fire pot has
gone out or the hopper may be empty. See the section on troubleshooting for assistance.
17
Publicidad
