Nilfisk SC370 43B Manual De Servicio página 48

Service Manual- SC370
Maintenance and Adjustment
Squeegee cleaning
1. Push the machine to a level floor.
2. Ensure that the machine is off.
3. Lower the brush/pad-holder deck and the squeegee by lifting the pedal.
4. Disconnect the vacuum hose (B) from the squeegee connector (C).
5. Loosen the knob (D) and remove the squeegee (E).
6. Clean the rubber or the plastic squeegee (E). Clean the compartments (I) and the hole (H) especially. Check
the front blade (F) and the rear blade (G) for integrity, cuts and tears; if necessary replace them (see the
procedure in the following paragraph).
7. Assemble the squeegee in reverse order of disassembly.
A B
Figure 2
38 Squeegee System 47
D
C
F G
E
I
H