MTD Yard-Man YM20CS Manual Del Operador página 5

INSTALL AND ADJUST T HE D-HANDLE
1. Push the D-handle down onto the shaft housing so that the
handle slants towards the shaft grip (Fig. 1). The squared
bolt hole in the handle is to the right.
Shaft Grip
Shaft Housinc
D-Handle
Minimum 6 inches
(15.24 cm)
Bolt
Tighten
Wing Nut
Washer
Fig. 1
2. Insert the shoulder bolt into the squared hole in the handle
and push through. On the left side of the handle, place the
washer on the bolt, then screw the wing nut onto the bolt.
Do not tighten until you make the handle adjustment.
3. Rotate the D-handle to place the grip above the top of the
shaft housing. Place it a minimum of 6 inches (15.24 cm)
from the end of the shaft grip.
4. While holding the unit in the operating position
(Fig. 2), position the D-handle to the location that provides
you the best grip.
5. Tighten the wing nut until the D-handle is secure.
INSTALL THE cu'n'ING A'n'ACHMENT SHIELD
Use the following instructions if the cutting attachment shield
on your unit is not installed.
_IWARNING: Neveroperatethetrimmerwithout I
the cutting attachment shield in place to prevent
serious personal injury.
Place the cutting attachment shield onto the shaft housing.
Be sure the guard mounting bracket slides into the slot on the
edge of the cutting shield. Rotate the shield into place,
counterclockwise. The holes in the guard mounting bracket
and cutting attachment shield will line up (Fig. 3).
2,
Shaft Housing
Cutting Attachment
Shield
Fig. 3
Guard
Mounting
Bracket
From insidethe cutting attachment shield, push the square bolt
through the hole until the threaded end protrudes through the
guard mounting bracket (Fig. 4).
Guard
Mounting \ Washer
Bracket _ _/-
-- ......... " Nut
,oo
Square Bolt tLLL_
Fig. 4
3. Put the washer on the bolt, then screw the wing nut onto
the bolt and tighten. Figure 5 shows the installation
process from underneath the unit.
Fig. 2
Square Bolt
Cutting _ Hole
Attachmen @_ washer Shield
Wing Nut
Cutting Attachment and Shield: Underside View
Fig. 5