Publicidad
Idiomas disponibles
Idiomas disponibles
HOLDING THE TRIMMER
I_,
ARNING:
Always wear eye, hearing, foot and
body protection to reduce the risk of injury when
operating this unit.
Before operating the unit, stand in the operating position (Fig.
12). Check for the following:
•
The operator is wearing eye protection and proper clothing
•
With a slightly-bent
right arm, the operator's
hand is
holding the shaft grip
•
The operator's left arm is straight, the left hand holding the
D-handle
•
The unit is at waist level
•
The cutting attachment is parallel to the ground and easily
contacts the grass without the need to bend over
Fig. 12
ADJUSTING
TRIMMING
LINE LENGTH
The Bump Head
TM
cutting attachment allows you to release
trimming line without stopping the engine. To release more line,
lightly tap the cutting attachment on the ground (Fig. 13) while
operating the trimmer at high speed.
NOTE:
Always keep the trimming line fully extended. Line
release becomes more difficult when the cutting line
gets shorter.
Fig. 13
Each time the head is bumped, about 1 inch (25.4 mm) of
trimming line releases. A blade in the cutting attachment
shield
will cut the line to the proper length if any excess line is
released.
For best results, tap the bump knob on bare ground or hard
soil. If you attempt a line release in tall grass, the engine may
stall. Always keep the trimming line fully extended. Line release
becomes more difficult when the cutting line gets shorter.
I
NOTE:
Do not rest the Bump Head
TM
on the ground while the
unit is running.
Some line breakage will occur from:
•
Entanglement with foreign matter
•
Normal line fatigue
•
Attempting
to cut thick, stalky weeds
•
Forcing the line into objects such as walls or fence posts
_[
AUTION:
Do not remove or alter the line cutting
blade assembly. Excessive line length will make the
clutch overheat. This may lead to serious personal
injury or damage to the unit.
TIPS FOR BEST TRIMMING
RESULTS
•
Keep the cutting attachment
parallel to the ground.
•
Do not force the cutting attachment. Allow the tip of the
line to do the cutting, especially along walls. Cutting with
more than the tip will reduce cutting efficiency and may
overload the engine.
•
Cut grass over 8 inches (200 ram) by working from top to
bottom in small increments to avoid premature line wear or
engine drag.
•
Cut from right to left whenever possible. Cutting to the left
improves the unit's cutting efficiency. Clippings are thrown
away from the operator.
•
Slowly move the trimmer into and out of the cutting area at
the desired height. Move either in a forward-backward
or
side-to-side
motion. Cutting shorter lengths produces the
best results.
•
Trim only when grass and weeds are dry.
•
The life of your cutting line is dependent upon:
•
Following the trimming techniques
•
What vegetation is being cut
•
Where vegetation is cut
For example, the line will wear faster when trimming against a
foundation
wall as opposed to trimming around a tree.
DECORATIVE TRIMMING
Decorative trimming is accomplished
by removing all
vegetation around trees, posts, fences and more.
Rotate the whole unit so that the cutting attachment
is at a 30 °
angle to the ground (Fig. 14).
Fig. 14
Publicidad
