MTD Yard-Man YM20CS Manual Del Operador página 6

OPERATING THEEZ-LINK
TM
SYSTEM
The EZ-Link
TM
system enables the use of these optional Add-
Ons.
Cultivator ................................... GC720r
Edger ....................................... LE720r
Hedge Trimmer ................................ TPAH*
Straight Shaft Trimmer ......................... SS725r
Turbo Blower ................................. TB720r
Pole Saw ..................................... TPPS*
Brushcutter ................................... TPBC*
*Do NOT use this attachment with an electric powered
)roduct.
WARNING: Before you begin using any
attachment, read and understand the manual that
came with the attachment. Follow all safety
information contained within.
2. While firmly holding the add-on, push it straight into the
EZ-Link
TM
coupler (Fig. 7).
NOTE: Aligning the release button with the guide recess will
help installation (Fig. 6).
3. Turn the knob clockwise to tighten (Fig. 8).
AI o,uzoo 'oc theree nthe I
primary hole (Fig. 7) and securely tighten the knob
before operating this unit.
90° Edge
Trimming Hole
Removing the Cutting Attachment or Add-Ons
I_, ARNING: To avoid serious personal injury and
damage to the unit, shut the unit off before
removing or installing add-ons.
1. Turn the knob counterclockwise to loosen (Fig. 6).
EZ-Link
TM
Coupler Release Button
\,,
Guide Recess
Fig. 6
2,
3.
Press and hold the release button (Fig. 6).
While firmly holding the upper shaft housing, pull the
cutting attachment or add-on straight out of the EZ-
Link
TM
coupler (Fig. 7).
EZ-Link
TM
Coupler
Primary Hole
Release Button
I
Fig. 8
CAUTION: The add-ons with the coupler system [
are to be used in the primary hole only. Using the [
wrong hole could lead to personal injury or damage[
to the unit. I
I
For decorative trimming/edging with the line head cutting
attachment, lock the release button of the cutting attachment
into the 90 ° hole (Fig. 8).
Upper Shaft Housing
Fig. 7
Lower Shaft Housing
Installing the Cutting Attachment or Add-Ons
NOTE: To make installing or removing the add-on
easier, place the unit on the ground or on a work
bench.
1. Turn knob counterclockwise to loosen (Fig. 6).