Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
3. PRODUCT ASSEMBLY
It is recommended that at least 2 people assemble the machine.
STEP 1 Assembling the sidebars
-
Unfold the sidebars as shown in figure 2. Align the screw holes of both bars with the base
frame.
-
First, insert a spring washer (S4) and a hexagon socket head cap screw (S2) on both sides
and tighten them with the Allen key (S8).
-
Then, insert two curved washers (S3) and two hexagon socket head cap screws (S1) at the
rear and tighten them with the Allen key (S8).
ATTENTION: DO NOT FULLY TIGHTEN THE BOLTS IN STEP 1 UNTIL YOU HAVE COMPLETED STEP 2.
STEP 2 Assembling the handlebars
-
Raise the handlebars to align the screw holes in the front of the fairing with the screw
holes in both support bars, as shown in Figure 3.
-
Insert a curved washer (S3) and a hexagon socket head cap screw (S2) on both sides and
tighten them with the Allen key (S8).
NOTE: while fitting the handlebar, make sure that the connecting cable inside the right-hand
support bar is securely connected, and be careful not to pinch it.
STEP 3 Assembling the console
-
Secure the console from the rear with the triangular retaining pins as shown in figure 4.
-
Insert the two pins (S5) and screw them in clockwise.
STEP 4 Assembling the decorative covers
-
4A. Assembling the left decorative cover:
-
Fit the cover by aligning it perfectly with the bolts of the base frame that you have screwed
in earlier as shown in figure 5.
-
4B. Assembling the right decorative cover:
-
Follow the same steps as on the left side.
-
Fit the cover by aligning it perfectly with the bolts of the base frame that you have screwed
in earlier as shown in figure 5.
STEP 5 Connection of the security key
Connect the safety key (S6) as shown in figure 6.
Warning:
Before you start training, remember to attach the safety key to your clothing using the clip. If it
falls, the clip will pull the safety key and the treadmill will stop immediately to prevent injury.
60
DRUMFIT WAYHOME 1600 RUNNER SPRINT
Publicidad
