Westinghouse WH3250 Manual Del Propietário página 15

4. Install the mounting feet to the frame using four
M6 x 18 mm bolts and M6 locking flange nuts (see
Figure 7).
,
6.
Figure 7 - Assemble Mounting Feet to Frame
1 - Mounting Feet 3- M6 Locking
2- M6 x 18 mm Flange Nuts
Bolts
Install the M12 x 105 mm wheel axle flange bolt
through the wheel (see Figure 8).
Thread the M12 serrated flange nut onto the bolt
with serrated edges facing away from the wheel.
Tighten the nut (see Figure 8).
Figure 8 - Installing Outside Serrated Flange Nut
,
Figure 9 -Assemble Wheels to Frame
1- Axle Bracket 2- Serrated Flange
Nut
Install the handles using the clevis pin and hairpin
cotter. Install the nylon washers on the outside and
inside of the handle as shown in Figure 10.
,
8.
1- Wheel Axle 2- Serrated Flange
Flange Bolt Nut
Install the wheel with bolt through the axle bracket
on the frame (see Figure 9).
Install the serrated flange nut and tighten (see
Figure9).
Figure 10 -Attaching the Handles
1- Clevis Pin 3- Nylon Washers
2- Handle 4- Hairpin Cotter
15