Publicidad
Idiomas disponibles
Idiomas disponibles
Attach the Steering Plate
1
2
1,2. Turn the steering plate until it can be fit to the vehicle body.
3. Turn the steering plate to line up the holes in the steering plate with the
holes in the vehicle body.
4. Fit the front axle to the vehicle body.
14
3
4
Attach the Front Wheels
Front wheel, more smaller
than Rear wheel.
5
6
7
8
Remove all the parts from the front axle.
1. Slide a Ø12 washer onto the front axle.
2. Slide the inner bushing onto the front axle.
3. Slide a Ø12 washer onto the front axle.
4. Slide a outer bushing (ring end first) onto the front axle.
5. Slide the front wheel onto the front axle, and keep it matching up with the outer
bushing.
6. Slide a Ø12 washer onto the front axle.
7. Tighten a locknut to the end of the front axle with a spanner.
HINT: An extra spanner has been provided to hold the locknut on the other side
of the rear alxe while tightening the locknut on the other side.
8. "Snap" the hubcap to the wheel cover.
Repeat for the other front wheel.
After assembling any wheel to the axles, please check the gap
between the screw thread and the collapsible (refer to the left
picture), if the gap is too big, please add two or three washers
inside the wheel, but after tightening the nut outside the wheel,
please turn the wheel by your finger to check if the wheel can
run smoothly, this is very important, because if the wheel can
GAP
run smoothly, it is ok, but if the nut presses the wheel and the wheel can't run
smoothly, the motor will be broken easily! Then you need to decrease one or two
washers to make sure the wheel can run smoothly!
Front axle
1
2
3
4
Tools required: Spanner
15
Publicidad
