cecotec BONGO M40 XL CONNECTED Serie Manual De Instrucciones página 32

ENGLISH
Fig. 23
1. Speed indicator
2. Configuration mode
3. Speed units
4. Drive mode
5. Light
6. Bluetooth
7. Cruise control
8. Pedestrian mode
9. Battery level
10. Brake lever and bell
11. Display
12. Power button
13. Accelerator
Note:
The graphics in this manual are schematic representations and may not exactly match the
device.
3. BEFORE USE
- This electric scooter comes in a packaging designed to protect it during transport. Take
the electric scooter out of its box and remove all packaging materials. You can keep the
original box and other packaging elements in a safe place. This will help you prevent
product damage when transporting it in the future. In case the original packaging is
disposed of, make sure all packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or not in good condition, immediately contact the official Cecotec Technical
Support Service.
Box content
Fig. 24
5. Bongo Serie M40 XL Connected electric scooter
6. Allen key
7. Charger
8. Screws x4
62 ORIGINAL MANUAL TRANSLATION
4. OPERATION
Assembly and configuration
Fig. 25
1. Fold out the handlebar, lock it and lower the kickstand.
2. Install the handlebar on the stem.
3. Tighten the screws on both sides of the stem with the T-shaped Allen key.
4. After assembly, press the power button to check for proper operation.
Charge your scooter
Fig. 26
The scooter is fully charged when the LED light on the charger changes from red (charging) to
green (continuous charging).
1. Open the rubber charging port cover.
2. Connect the charger to the charging port.
3. When charging is complete, re-attach the rubber cover.
How to ride
Warning: use helmet and elbow/knee pads. Please read the instructions carefully before
using the product. Do not modify the braking system. Check the instructions for further
information.
1. Switch on the scooter and check the power indicator.
2. Place one foot on the deck and push off the ground with the other foot. When the
scooter starts to coast, place both feet on the deck and press the accelerator. Note:
Acceleration will start when the coasting speed exceeds 5 km/h.
3. The accelerator automatically switches off when the scooter is at a complete standstill.
To restart the scooter, repeat step 2.
4. Release the accelerator and the Kinetic Energy Recovery System (KERS) will
automatically start to brake slowly; press the brake lever to brake suddenly.
5. Tilt your body in the direction of steering when turning and slowly turn the handlebar.
Control panel
- Switch-on: one short press.
- Switch-off: a long press for 2 seconds.
- Light: two short presses.
- Drive mode: one short press.
1. PEDESTRIAN mode: In this mode, the scooter can reach 6 km/h.
2. COMFORT mode: In this mode, the scooter can reach 15 km/h.
3. SPORT mode: In this mode, the scooter can reach 25 km/h.
- Cruise control: three short presses.
- Speed units: 5 short presses.
- Gyroscope: hold down the brake lever and short-press seven times.
ENGLISH
BONGO SERIE M40 XL CONNECTED 63