cecotec BONGO Y 45 Manual De Instrucciones página 32

ENGLISH
Box content
Fig. 25
1. Electric scooter
2. Adapter
3. Tools required for assembly
4. Instruction manual
4. PRODUCT ASSEMBLY
Assembly
1. Fold out the handlebar, lock it and lower the kickstand.
2. Connect the wires protruding from the handlebars to their corresponding connector on
the stem.
3. Install the handlebar on the stem.
4. Tighten the screws on both sides of the stem with the T-shaped Allen key.
5. After assembly, press the power button to check for proper operation.
Folding mechanism. Fig. 26
1. Release the safety lock.
2. Pull the lever all the way down to its maximum lower position.
3. Pull the stem backwards.
4. Attach the hook to the hook ring to fold the scooter.
Charging the electric scooter
1. Make sure the electric scooter is switched off before and during charging.
2. Connect the charger to the electric scooter's charging port and connect the charging plug
to a power outlet.
- Charge the electric scooter for at least 8 hours before first use.
- The charger indicator light will illuminate green when 100% charge is reached.
- Never use the electric scooter while it is charhing.
- Do not charge the electric scooter for longer than necessary.
- To maximise battery life, charge the battery at least every three months.
- Be sure to charge the electric scooter in a dry and clean environment. The input voltage is
100-240 V. Connect the charging cable securely to the charging port of the electric scooter.
Note
Stop charging the battery when the indicator colour changes to green. Do not exceed the
battery charging time so as not to affect its shelf life.
62 BONGO SERIE Y 45
BONGO SERIE Y 65
ORIGINAL MANUAL TRANSLATION
WARNING!
Cover the charging port with the dirt cap to prevent any metallic object from coming into
contact with it and to avoid short circuits.
If the voltage is below 44.8 V, the undervoltage alarm will be activated, and the battery
indicator will flash on the display. If the voltage is below 32.5 V, it will enter in undervoltage
protection mode, and the battery indicator will flash on the display.
5. OPERATION
1. Switching the scooter on/off:
Press and hold the power/light button to turn the scooter on or off. After 10 minutes of
inactivity, the electric scooter will automatically switch off.
2. Switching the lights on/off:
- Press the power/light button once to turn the headlight and taillight on or off.
- Press the power button twice in succession to switch the decorative light on or off.
3. Driving modes:
Press the driving mode selector/speed unit button to select between the different modes:
- Pedestrian mode: in this mode, the scooter can reach 6 km/h (3 mph).
- Eco mode: in this mode, the scooter can reach 15 km/h (9mph).
- Comfort mode: in this mode, the scooter can reach 20 km/h (11 mph).
- Sport mode: in this mode, the scooter can reach 25 km/h (15 mph).
4. Press the power button 3 times in succession to change the unit of speed (km/h or mph).
5. Press the power button 5 times in succession to activate/deactivate the cruise control.
Tyre use
- For a correct operation of the electric scooter, you should check and ensure the correct
pressure on the wheels before every use.
- The optimum pressure for these tyres is de 36 PSI / 2.5 bars / 250 kPa.
- We recommend you carry out periodic checks to ensure the pressure is within the
recommended values to achieve efficient operation.
- During the shelf life of the wheels we recommend using heat-sealing gels to prevent
punctures and maintain maximum effectiveness and performance.
ENGLISH
BONGO SERIE Y 45 63
BONGO SERIE Y 65