Publicidad
Idiomas disponibles
Idiomas disponibles
EN
24
PREPARATORY WORK AND FUNCTIONS
1 Prepare ISOFIX
1. If your car is not equipped with the ISOFIX guide socket, please insert the
guide socket into the ISOFIX anchor.
TIP: ISOFIX anchors are located between the backrest and seat cushion.
2. Press the ISOFIX button push rearward to the longest.
2 Prepare Top Tether
1. Pull out the Top Tether and press the tether strap release button to extend
the strap until it is long enough to connect it to the Top Tether anchorage
point in the vehicle.
2. If the Top Tether is tightened favorably and correctly, the button will
change to green.
3 Adjust harness and headrest
3.1 Adjust harness and headrest in the
5-point harness installation (from 40
up to 105 cm)
1. Press down on the central adjuster
and pull the shoulderbelts towards
you, (DO NOT pull on the shoulder
pads ) release the 5-point harness as
far as it will go.
2. Pull upwards on the adjusting handle whilst pulling up or pushing down
the headrest to the required position.
Adjusting the height of the headrest will allow for the shoulder belts to be the
same level as the child's shoulders.
3.2 Adjust headrest (from 100 cm up to 150 cm)
1. Make sure the 5-point harness is removed.
2. Make sure the seat cushion is removed.
3. Press on the adjusting handle in the direction of
the arrow to release the headrest , and then adjust
the headrest up or down to the desired position.
Upon release of this handle , the headrest will lock
into place automatically.
4. The headrest is in the correct position when the
diagonal belt section of the 3-point vehicle belt
sits on thechild's shoulders and when you can fit
Publicidad
