Publicidad
Idiomas disponibles
Idiomas disponibles
For your child's safety, ensure that the following checks are carried out
before every journey:
•
The ISOFIX connectors are securely engaged in the anchors and the
indicators are both completely green.
•
The child restraint is sat up against the backrest of the vehicle seat.
•
The 5-point harness is fitted snugly to the child. Make sure you can
fit no more than one finger between the harness and the child's
body, approximately 1 cm. If there is more space, tighten the harness
further.
•
The straps are not twisted.
•
The shoulder straps sit in the correct position on the child's shoulders.
•
Any lap strap must be worn low down, so that the pelvis is firmly engaged.
•
The 5-point harness buckle is properly secured.
1.3 Fix the Top Tether
1. Prepare the Top Tether after your child is secured by 5-point harness with
the rearward facing.
2. Place the Top Tether strap through the gap between the
headrest and the backrest, then connect the Top Tether
anchorage. If the Top Tether is tightened favorably and
correctly the button will change to green.
2 Forward Facing lnstallation
2.1 (76-105 cm, from approx. 9 months to 4 years) with
5-point harness + ISOFIX + Top Tether
1. Prepare the ISOFIX.
2. Ensure that the 5-point harness is correctly installed.
3. Ensure that the 5-point harness is correctly adjusted.
4. Adjust the child car seat to the desired recline position and ensure that
recline mechanism is securely locked.
5.
Ensure that the child car seat is in the forward facing position and the
rotation mechanism is securely locked.
6. Place the child restraint on the vehicle seat facing the front of the vehicle
in the direction of travel.
7. Install the ISOFIXconfirm that the indicator turns green.
8. Push the child car seat towards the backrest applying firm, even pressure
on both sides.
9. Secure your child in the child car seat with 5-point harness.
10. Prepare the Top Tether after your child is secured by 5-point harness with
the forward facing, follow the steps described in point 2.2.
EN
27
Publicidad
