Descargar Imprimir esta página

Husqvarna 542i XP Manual Del Usuario página 33

Publicidad

Idiomas disponibles

Idiomas disponibles

4. Examine the groove in the guide bar for wear.
Replace the guide bar if it is necessary.
5. Examine if the guide bar tip is rough or very worn.
6. Make sure that the bar tip sprocket turns freely and
that the lubricating hole in the bar tip sprocket is not
blocked. Clean and lubricate if it is necessary.
User interface
LED screen
Possible faults
The warning in-
Chain brake is
dicator flashes.
engaged.
Temperature
deviation.
Overload. The
saw chain can
not move.
The power trig-
ger and the
start/stop but-
ton are pushed
at the same
time.
Green activate
Low battery
LED flashing.
voltage.
2022 - 003 - 07.09.2023
Troubleshooting
Possible solution
Disengage the chain brake.
Let the product to cool down.
Release the saw chain.
Release the power trigger to activate the product.
Charge the battery.
7. Turn the guide bar daily to extend its life cycle.
To adjust the chain oil flow
WARNING:
make adjustments to the oil pump.
Turn the adjustment screw for the oil pump. Use a
screwdriver or the combination wrench.
a) Turn the adjustment screw counterclockwise to
increase the oil flow.
b) Turn the adjustment screw clockwise to decrease
the oil flow.
Stop the motor before you
33

Publicidad

loading

Este manual también es adecuado para:

542i xp g