MSG Equipment MS006 Manual De Usuario página 10

English
Test bench MS006
«PRINTER SETTING» – connection of a Bluetooth-printer to the test bench;
«MANUAL TEST SETTING» – manual test mode setting, has several parameters:
– «Enable start check for short circuit» – enable the start check for short circuit;
– «Enable K15 in for COM type terminal» – to enable terminal 15 (ignition) for COM alternators;
– «Reverse rotation» – to reverse the rotation of the drive;
– «Print result in exhibition mode» – to print out test results in presentation mode.
«SET MEASUREMENT COEFFICIENT» provides an access to the bench calibration menu which is
used to adjust the bench by the manufacturer specialists only.
«LIN ANALYZING» – Lin bus data reading menu.
WARNING! It's forbidden to make any changes in bench calibration without manufacturer
specialist assistance.
In the menu window SELECT ALTERNATOR BY TYPE (fig. 6) you can choose the rated voltage (12 V
or 24 V) and the type of the diagnosed alternator. The chosen parameter is highlighted.
In case the alternator diagnostics requires the rotation rates that are equal to the rates of a car,
press the buttons "-" / "+" to set the sheave diameter that is similar to the sheave diameter of a
car. To confirm the settings, press USE.
Press TEST to go to diagnostics mode.
10
Figure 6. Alternator selection menu