MSG Equipment MS006 Manual De Usuario página 8

English
Test bench MS006
• "ROTATION SPEED": knob to set/adjust the drive speed (RPM) and rotation direction. Press the
knob shortly to stop the drive.
5 – Diagnostic terminals: to connect the test bench to the voltage regulator terminals:
• "B+": test bench terminal to connect to the alternator terminals: "B+", "IG", "S", "AS', "BVS", "A",
"15";
• "L/D+": output to the voltage regulator control lamp; it is connected to the following terminals:
"L", "D+", "I", "IL", "61";
• "GC": alternator control terminal. It is connected to the terminals "COM", "LIN", "D", "RLO", "C",
"G", "SIG", "L(RVC)", "RC";
• "FR": alternator load control; it is connected to the voltage regulator terminals: "FR", "DFM",
"M", "LI".
A set of four diagnostic cables MS0105 (Fig.3) is included in the package set.
Diagnostic cables are connected to the test bench terminals (Fig.2, n.5), observing the color
marking.
The test bench main menu (Fig. 4) contains:
"SELECT ALTERNATOR BY TYPE" - menu to select the alternator type;
"SELECT ALTERNATOR BY NUMBER" - menu to select the alternator by its serial number;
"SETTINGS" - test bench parameters menu;
"INFORMATION" - "About the test bench" menu.
8
Figure 3
4.1. Test bench menu