Kärcher RCF 3 Manual Del Usuario página 18

Home button
20
LED display indicator "Fresh water"
21
Filling the fresh water tank
LED display indicator "Robot status"
22
Scraper unit with hair comb
23
Cleaning tool
24
Fresh water tank
25
Waste water tank
26
Opening lever of waste water tank
27
Mains cable
28
Detergent (30 ml)
29
Cable fasteners
30
Symbol
WLAN
Battery
18
● The mobile cleaning robot draws its energy from a
● As soon as the charging process is finished, the
● The cleaning robot moves systematically. It scans
● The cleaning robot has fall sensors that can detect
● The ultrasound sensor detects carpets and avoids
● The cleaning robot has a fresh and a waste water
LED symbols on the display
LED
pulses blue
flashes red
lights up blue
off
lights up green
lights yellow
flashes red
flashes green
off
English
Function of the cleaning robot
built-in rechargeable battery, which it regularly re-
charges at the charging station provided. With one
battery charge, the cleaning robot can clean up to
125 minutes in sensitive mode. It automatically re-
turns to the charging station to recharge when the
battery charge is too low.
cleaning robot automatically leaves the charging
station and continues the cleaning work. The clean-
ing robot also returns to the charging station when it
has finished cleaning.
the room with a laser sensor (LiDAR) and then
cleans the room step-by-step. It avoids obstacles
that are at least as high as the LiDAR tower.
staircases and steps, designed to prevent it from
falling.
them during wet cleaning.
tank as well as a microfibre roller that is regularly
moistened with fresh water and continuously cleans
itself through its rotation, thereby thoroughly wet
mopping the floor. At the same time, light loose dirt
such as crumbs, dust fluff etc. can be picked up
along with the mopping process. Dirty water is con-
veyed into the waste water tank via the roller. Parti-
cles are collected in the scraper unit with hair comb
and partially transported into the waste water tank.
Meaning
The device is connected to WLAN.
The WLAN is reset.
The robot is offline.
The robot is connected to WLAN.
The device is switched off.
The device is in sleep mode.
The device is in "Do not disturb" mode.
The device is no longer connected to
WLAN.
LED lights up when the battery is fully
charged and up to a remaining battery
run time of 30%.
LED lights up starting at a remaining
battery run time of 29% to 10%
LED flashes starting at a remaining
battery run time of 9%
The device is charging.
The device is switched off.
The device is in sleep mode.
The device is in "Do not disturb" mode.