To Insert Needles (S); Presser Foot Lift; Change Presser Foot - JUKI MO-80CB Manual De Instrucciones

Maquina de coser sobreorilladora da 2 agujas, 3/4 hilos
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

(3) TO INSERT NEEDLES (S)

* Hold the needle with the flat surface to the back.
* Insert the needle into the needle socket as far as it
will go.
* When inserting a needle, if you first lower it down
into the hole in the stitch plate it will line up with
the needle socket. Then direct it upwards.
Note : When inserting needles into the A or B
sockets it is necessary to loosen both A & B
allen Screws. After inserting the needles
equally tighten both screws*
This machine uses ELx705 needles. Do not use
Standard Household Needles.

11. PRESSER FOOT LIFT

* Raise the presser foot by left down presser foot lift
lever at the left side of the machine.
* Take down the presser foot lift lever down
the presser foot in the extra lift position.

12. CHANGE PRESSER FOOT

Turn off the main power switch and unplug
the machine.
* Raise the presser foot.
* Turn the hand wheel toward you until the needles
are at the highest position.
* Push the red button on the back of the presser
foot ankle to release the presser foot.
* Raise the presser foot to the extra lift position and
the foot will come off.
* Place the new foot with the pin right underneath
the groove of the ankle while in the extra lift
position.
* Lower the presser foot. Push the red button on the
back of the presser foot ankle and the foot will
snap into place.
31
To tighten
To loosen

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido