Telescopic Thread Stand; Preparation For Threading; Setting Up The Thread Guide Holder; Anti-Spill Net - JUKI MO-80CB Manual De Instrucciones

6. TELESCOPIC THREAD STAND

* Place the thread spools over the cone holders on
the spool pin.
* If the machine is already threaded, straighten the
threads to prevent tangling.

7. PREPARATION FOR THREADING

(1) SETTING UP THE THREAD GUIDE
HOLDER
* Fully extend the thread guide holder.
* The two joints on the telescope will click into place
when they are correctly positioned.
* Center the thread guides above the spool pins.
* Place thread over the cone adapters on the spool
pins.
Note : Your new machine is threaded to sew
"4-Thread Overlock". Refer to Page 35 for
instructions on tying onto the threads.

(2) ANTI-SPILL NET

* When using synthetic threads that easily spill off
the cone, slip the anti-spill net furnished with the
machine over the thread from the bottom of the
cone leaving the thread end hanging free at the
top the anti-spill net as shown at right.
25
Anti-spill net
Filet anti-déroulement
Red antiderrame