To Thread Lower Looper Thread (Red) - JUKI MO-80CB Manual De Instrucciones

* Thread the looper area of the machine following
the green color coded thread guides (4)~(7).
* Thread the hole in the upper looper from front to
back (8).
Note : Make sure thread passes behind lower
looper.
Note : Use tweezers provided in the accessory case
to aid in threading the looper.
* Pull about 10cm (4 inches) of thread through the
looper and place to the back of the stitch plate.
(2) TO THREAD LOWER LOOPER
(RED)
Thread the lower looper as indicated (1)~(8).
* Raise Presser foot to release Tension discs.
* Pass thread from back to the front through the
thread guide (1).
* Thread the thread guide A (2) by pulling the thread
towards the left until it slips under guide.
Then pull thread along the path as illustrated.
THREAD
2
39
8
7
4
6
5
5
8
7
5
6
2
8
7
1
2
3
4
1