Publicidad
Idiomas disponibles
Idiomas disponibles
22
Exchange of endless tape magazine
If vou should need different
messages and do not wantto
record them again on each occasion
it is
recommended
to have various
cartridges
available.
Spare cartridges
are available
at vour dealer.
The cartridge
is to be exchanged
as foliows:
Remove tape from its guides (tape pressure spring @ and rubber pressure roller @ marked read)
loosen fastening screw @ of cartridge with the help of a coin and lift up cartridge trom its resting
post.
The new cartridge can now be inserted (the shaft at the bottom of the magazine must fit into the
opening provided on the platform of the T 104). Refasten the cartridge with screw @. The tape
path is marked in white on the platform of the machine. Start inserting the tape loop at the right
hand side. For this purpose the rubber pressure roller and the tape pressure spring are once again
to be released at the levers marked in red.
In case the tape loop should
be too narrow, pull some more tape out o(the
cartridge
on the left
hand side. If, however, the loop should be too wide,do
not attempt to replace it into the cartridge.
The tape tightens
itself whilst
running.
Unrequired
f;:artridges please keep in their original
packing
cartons.
Service and maintenance
When observing
a certain amount
of attention
which
is self-evident
for aprecision
product
like
the T 104, the set works trouble-free
also during
permanent
use. You should
occasionallv
clean
heads, tape guides and rubber roller with a piece of cloth saturated
in methvlspirit.
In case the
rubber pressure roller @ is cleaned please make sure that a thin film
of talcum
powder
is put on
the rubber roller. BV doing this vou avoid a sticking
of the tape on the rubber. Your dealer will
only be too pleased to attend
to these small requirements.
Should
it become
necessarv to ex-
change a lamp or a fuse, please also contact your dealer.
Publicidad
