Urmet K-Steel 1038/16 Manual Del Usuario página 21

DESCRIPTION OF TERMINALS
MP1 - Main voice terminal board 1
+V Power positive (+24V)
0V Power and data line earth
D Data line
FA1 Voice wire 1 out
FB1 Voice wire 1 back
MP2 - Main voice terminal board 2
FA2 Voice wire 2 out
FB2 Voice wire 2 back
+F Voice power positive (+33V)
0F Voice earth
MS - Secondary terminal board
+V Power positive (+24V)
0V Power and data line earth
D Data line
FA Voice wire out
FB Voice wire back
MA - Auxiliary terminal board
SE- Electrical lock control output - negative
SE+ Electrical lock control output - positive
0V Key/contact/button common
T2 Dedicated call button 2 input
T1 Dedicated call button 1 input
SP Door sensor input
H Door opener code inhibit contact input
P Postal key contact input
PH Hall door opener button input
MV - Video terminal board
+V Video Ref. 1038/8 relay box power
SC Video Ref. 1038/8 relay control output - riser
SL Video Ref. 1038/8 relay control output - local
S12 Video Ref. 1038/8 relay control output -
channels 1/2
0V Video Ref. 1038/8 relay box relay
S1 Video Ref. 1032/9 relay control output
for channel 1
S2 Video Ref. 1032/9 relay control output
for channel 2
0V Relay Ref. 1032/9 device earth
DS1038-011B
SPECIFICATIONS
Current consumption in terms of unitary loads:
− Logic circuits
Logic power voltage (+V/0V) : 15 - 25.2 Vdc
Maximum current draw:
− Voice circuits
Voice power voltage (+F/0F): 30 - 36 Vdc
Operating temperature range:
Index of protection:
OPERATION
CALL BY SELECTING NAME
In normal operating conditions, the following message
for prompting the name to be called will appear:
Select NAME
with ↑ or ↓
Use the two scroll buttons (3) to select the name to
be called and press the
name. The following message will appear:
ENTERED
NOTE: Simply press the
prompt to call the concierge switchboard.
Three beeps will be heard to confirm that the call is
being forwarded.
The apartment door phone will ring for the
programmed time (from 1 to 5 seconds) with either
continuous tone (main calling module) or intermittent
tone (secondary calling module).
The selected name will reappear for 30 seconds.
Simply press the button again to make the door
phone ring again.
The following conversation prompt will appear when
the apartment door phone answers:
During the conversation, the following message will
appear on the display for three seconds and three
beeps will be heard if the door lock is operated:
15 UL
400 mA
-10 - +50 °C
IP45.
button to call the selected
CALL
button from the selection
PLEASE
SPEAK
21