Urmet K-Steel 1038/16 Manual Del Usuario página 28

LOCAL PROGRAMMING VIA KEYPAD
− Enter "00" followed by four digits. Press the
button. The following will appear if the password
is wrong:
INCORRECT
PASSWORD
The password entry procedure will be locked after
the third attempt. The timeout will increase with the
number of failed attempts:
No. of failed
1
2
3
4
5
6
.
.
255 252 minutes (over four hours)
Enter the correct password. The following will appear
on the display:
<Names>
<Lock rel.><Esc>
− Select <Door codes> and press the
The first two door opener codes will appear on
the first page:
Lrl001:00000000
Lrl002:00000000
− Enter the door opener code and press the
button to confirm.
− Use the scroll buttons to check the entered codes
and go to the new codes.
− Hold the X button pressed for longer than three
seconds to quit the code entry procedure and
return to normal operation.
NOTE 1: Hold the
three seconds to find the first free space
instead of scrolling all the codes with the
scroll arrows.
NOTE 2: Set a door opening code to "00000000" to
delete it.
28
Stand-by time before
attempts next attempt to
enter password
-
-
-
1 minute
2 minutes
3 minutes
.
.
button pressed for longer than
CLEARING THE DIRECTORY
In some cases, you may need to clear all the
names from the calling module with directory (e.g.
to re-install a device in another building).
This procedure is only possible from the keypad.
− Enter "00" followed by the four digit configuration
password (NOT the door opener code management
password). The main menu will appear:
− Press the
The following will appear on the display:
− Answer "Yes" to delete both the door opener
codes and the names (see below) stored in the
device. Answer "No" to access the following two
options, i.e. delete names ONLY or delete door
opener codes ONLY:
button.
Answer "No" to the first question and "Yes" to the
second question to delete the door opener codes
only.
NAME MANAGEMENT
Up to 740 names can be stored. Each name will
include the following information:
− The user's name (up to 32 alphanumeric
characters on two 16 character rows).
− The user's code, alphanumeric (included from "1"
to "JJJJ").
− Door opener code, numeric only (included from
"1" to "99999999").
More than one name (different names) can be
associated to the same calling call (for several
people living the same apartment).
To make the calling code appear next to the name,
simply store the calling code next to the user's name
using the 32 available characters.
<LANGUAGE><CONF>
<ID><TEST><ESC>
button and 5 at the same time.
Eliminate ALL?
<Y> <N>
Erase names?
<Y> <N>
Erase lock rel.?
<Y> <N>
DS1038-011B