Publicidad
Idiomas disponibles
Idiomas disponibles
CALL T.: 3s
<1><2><3><4><5>
VOICE LINES:1
BUZZER LEV:MED
<MIN><MED><MAX>
KEY 1:0000
KEY 2:0000
PASSWORD: 9998
The programming method is the same for all the
pages.
− Use the scroll arrows to move the cursor to the
required option and press the
and go to the next page.
− Use the number keys (and alphabetic keys, if
an additional alphabetic keypad Ref. 1038/73
is fitted) to enter codes where required. Press
the X button to correct mistakes and restore the
previous setting.
The main menu will appear again when the
programming procedure is over:
<LANGUAGE><CONF>
<ID><TEST><ESC>
Select <ESC> and press the
return to normal operation.
NOTE: Simply hold the X button pressed for longer
than three seconds to quit programming and
return to normal operation. The data entered
to this moment will be stored.
DOOR OPENER CODES
Up to 240 door opener codes, unrelated to names,
for general use, can be stored in the calling module.
The door opener codes can be numeric only. Each
code consists of a variable number of digits (from 1
to 8). Consequently, the code will be included in the
range from 1 to 99999999.
DS1038-011B
<1> <2>
0000
0000
9998
button to confirm
button to confirm to
METHODS
The following methods can be used to store the
door opener codes:
1) Via programming terminal Ref.1038/55, connected
locally or in any point in the system.
2) Locally, via the keypad. In this case, you will
need to know the password for programming
names and door opener codes (which is
DIFFERENT from the configuration password).
PROGRAMMING VIA TERMINAL 1038/55-/56
After establishing a logical connection with the
calling module (see paragraph "PROGRAMMING
VIA TERMINAL 1038/55-/56") go to the following
page:
<Names>
<LockRel.>
<Program>
<Cancel><Exit>
− Select the <Door code> option and press ↵. The
first three door opener codes will appear:
Lrl001:00000000
Lrl002:00000000
Lrl003:00000000
<P><N><OK><ESC>
− Enter the required code(s), go to the <OK>
command with ← and → and press ↵.
IMPORTANT: THE THREE CODES WILL ONLY
BE STORED IN THE CALLING MODULE AFTER
CONFIRMING WITH THE <OK> BUTTON. A
visual confirmation will be given.
− Select <S> and press ↵ to access the following
three codes. Alternatively, select <P> and press
↵ to access the previous three codes.
− After programming the codes, select <ESC> and
press ↵. Press ← to go to the previous page,
select <Quit> and press ↵.
− Disconnect the programming wire and hold
the "OFF" button pressed for longer than three
seconds to switch the terminal off. Alternatively,
repeat the steps above to program the door
opener codes for other calling modules in the
system.
NOTE: Set a door opening code to "00000000" to
delete it.
27
Publicidad
