Urmet K-Steel 1038/16 Manual Del Usuario página 32

device. Answer "No" to access the following two
options, i.e. delete names ONLY or delete door
opener codes ONLY:
Elimin.names?
Elimin. lock rel?
Answer "Yes" to the first question to delete the
names ONLY.
INSTALLATION
IMPORTANT:
Observe the instructions contained in the
"Integrated System Technical Manual" for
wiring and maximum distances.
The calling module must be fitted in K-Steel
embedding boxes, e.g. Ref. 1152/62 (not provided).
For fitting, loosen the two tap screws and remove
the crossbar from the embedding box frame. Then
fasten the calling module to the frame by means
of seven M3 screws (provided) as shown in the
figure.
32
<Y> <N>
<Y> <N>
Tamperproof screws are provided with the K-Steel
frame for greater security.
The additional alphabetical keypad Ref. 1038/73
can only be fitted under, or, if this is not possible, by
the side of the calling module. In the first case, use
the three module embedding box Ref. 1155/63.
ADJUSTING THE VOLUME
The volume to apartment station is calibrated at
the factory and does not need to be adjusted. The
speaker volume is set at the factory to a medium
value. Turn the trimmer (9) with a screwdriver to
adjust, if required.
ADJUSTING THE DISPLAY CONTRAST
The display contrast level is set at the factory
to an optimal level. Turn the trimmer (11) with a
screwdriver to adjust, if required.
DS1038-011B