Urmet K-Steel 1038/16 Manual Del Usuario página 26

LOCAL PROGRAMMING VIA KEYPAD
Use either of the following two methods to access
the programming environment:
a) If the configuration password is known (the
factory-programmed password is "9998"), enter
"00" followed by four digits. Press the
The following will appear if the password is
wrong:
INCORRECT
PASSWORD
The password entry procedure will be locked after
the third attempt. The timeout will increase with the
number of failed attempts:
No. of failed
1
2
3
4
5
6
.
.
255 252 minutes (over four hours)
b) If the password is not known, open the K-Steel
frame and press the red button (10) on the
back.
The following will appear for a few seconds after
entering the correct password or pressing the
red button (10):
v1.0B
N.S.uvwxyz
The first indication is the software version (in
this case 1.0) and the maximum number of
programmable door opener codes (240, letter
"B" will appear). The version date and the device
serial number (S/N "uvwxyz") which corresponds
to the serial number on the rear label will appear.
This information is useful for checking the serial
number without having to open the K-Steel
frame.
At this point, the main menu will appear:
<LANGUAGE><CONF>
<ID><TEST><ESC>
26
Stand-by time before
attempts next attempt to
enter password
-
-
-
1 minute
2 minutes
3 minutes
.
.
23/03/99
a) Using the arrow keys, move the cursor
to <LANGUAGE> and press the
to access the screen form used to select
operating language. The first screen form is
as follows:
button.
Move the cursor to the required language
and press the
b) Move the cursor to <ID> to program the
installation location and press the
The following will appear:
Use buttons ↑ and ↓ to scroll the characters that
can be entered. Press the
the selected character in the upper row of the
display. Up to 30 characters can be entered,
(starting from the time the 16th character is
entered, the top line scrolls progressively to
the left), we strongly recommend you limit
the name to 15 characters. This is because
only 15 characters will be displayed during
terminal search.
After this procedure, take the cursor to the
shortcut menu: <ESC><Del><End>. To do
this, hold button ↓ pressed until the cursor
is on the "E" in <Esc>. To confirm the name,
select <End> by means of the ↑ button and
press the
c) Move the cursor to <CONFIG> and press
the
configuration parameters in the following
sequence of pages.
<ITA> <FR> <ENG>
<DEU> <ESP> < >
button.
<Esc><Del><End>A
button.
button to program the eleven
MOD. TYPE:
<MAIN> <SECOND>
MODULE CODE:JJJ
JJJ
BUSY T.:10s
<10><20><30><40>
LOCK REL. TYPE:
<FREE> <SEC>
LOCK REL. T. 0s
<-> <+> <OK>
key
button.
button to enter
DS1038-011B