Unpacking And First Operation; Unpacking And First Operation Of The Piston Burette; Connection And Installing Of Piston Burette And Magnetic Stirrer Tm 50 - Xylem SI Analytics TITRONIC 300 Manual De Instrucciones

59
2

Unpacking and First Operation

2.1 Unpacking and First Operation of the Piston Burette

The piston burette itself as well as all related accessory and peripheral parts have been carefully checked at the
factory to ensure their correct function and size.
Please ensure that the small accessories are also removed in full from the packaging.
For the scope of delivery, please refer to the enclosed parts list.
®
The TITRONIC 300 piston burette may be placed on any flat surface.

2.2 Connection and installing of Piston Burette and magnetic stirrer TM 50

The low voltage cable of the power supply TZ 1853 has to be plugged in to the 12 V socket „in", (see Fig. 3 back
panel, chapter. 2.3), on the back panel of the Piston Burette. Then plug the power supply into the plug socket.
Fig. 1a)
Place the power supply easily accessable in order to be able to remove the Piston Burette anytime easily from
the power circuit.
The stirrer connects to the right side at the bottom and is locked in position by pushing it backwards (Fig. 1).
In this way the power supply of the TM 50 stirrer is automatically established.
Fig. 1b
Fig. 1b) Fig. 2)
The stand rod TZ 1748 is screwed into the thread and the titration clamp Z 305 may now be mounted on the
stand rod. (Fig.2). Instead of the magnetic stirrer TM 50, also the titration stand without stirring function (TZ3886)
can be connected.