Franke Country FCO 86 H Manual De Usuario página 15

Cleaning and maintenance
Do not use steam cleaning equipment.
Carry out the required operations with
the oven cold.
Do not use wire wool, abrasive scourers or
abrasive / corrosive cleaning agents, as these
could damage the surfaces of the appliance.
Use protective gloves during all
operations. Disconnect the appliance from
the power supply.
Exterior surfaces
▶ Clean the surfaces with a damp microfibre
cloth. If they are very dirty, add a few drops
of pH-neutral detergent. Finish off with a dry
cloth.
▶ Do not use corrosive or abrasive detergents.
If any of these products inadvertently comes
into contact with the surfaces of the
appliance, clean immediately with a damp
microfibre cloth.
Interior surfaces
▶ After every use, leave the oven to cool and
then clean it, preferably while it is still warm,
to remove any deposits or stains caused by
food residues. To dry any condensation that
has formed as a result of cooking foods with
a high water content, allow the oven to cool
completely and then wipe it with a cloth or
sponge.
▶ Activate the "Steam cleaning" function for
optimum cleaning of the internal surfaces.
▶ The door can be easily removed and refitted
to facilitate cleaning of the glass.
▶ Clean the glass in the door with a suitable
liquid detergent.
Accessories
Soak the accessories in a washing-up liquid
solution after use, handling them with oven
gloves if they are still hot. Food residues can
be removed using a washing-up brush or
a sponge.
FCO 86 H / FCO 82 H
Removing and refitting the door
The oven door can be removed quickly and
easily. To do so, proceed as follows:
1. Open the door fully.
2. Lift the two levers shown in the figure below.
3. Close the door as far as the first stop (caused
by the raised levers).
4. Lift the door upwards and outwards to
remove it from its mountings.
To replace fit the door, fit the hinges in their
mountings and lower the two levers.
Press to clean - cleaning the glass
1. After removing the door and resting it on
a soft surface with the handle downwards,
simultaneously press the two retaining clips
and remove the upper edge of the door by
pulling it towards you.
2. Lift and firmly hold the inner glass with both
hands, remove it and place it on a soft
surface before cleaning it.
3. To reposition the internal glass correctly,
make sure that the glossy black frame of the
glass is facing upwards.
15
EN