Franke Country FCO 86 H Manual De Usuario página 16

EN
4. Refit the upper edge: a click will indicate
correct positioning. Make sure the seal is
secure before refitting the door.
Replacing the lamp
1. Disconnect the oven from the power supply.
2. Remove the cover from the light, replace the
bulb and put the cover back on the light.
3. Reconnect the oven to the power supply.
1
Troubleshooting
1
Problem
The oven does not work.
Support
In the event of any operation problems, contact
a Franke Technical Service Centre.
Never use the services of unauthorized
technicians.
Specify:
– the type of fault,
– the appliance model (art./Code),
– the serial number (S.N.) on the rating plate,
located on the bottom edge of the oven
cavity (visible when the oven door is open).
2
230V - 25W G9
2
3
230V - 25W E14
Possible cause
Power cut.
Disconnection from the mains.
FCO 86 H / FCO 82 H
Note: The bulb used in the product is
specifically designed for domestic appliances
and is not suitable for general room lighting
within the home (EC Regulation 244/2009).
Light bulbs are available from our After-sales
Service.
If using halogen bulbs, do not handle
them with your bare hands as your fingerprints
could cause damage. Do not use the oven until
the light cover has been refitted.
When contacting our Service Centre, please
state the codes provided on your product's
rating plate.
XXXXXXXXXX
XXXXXXXXXX
XXXXXXXXXX
XXXXXXXXXX
XXX X X X X X XXX XX XXXX X X X
XXXXX
16
Solution
Check for the presence of
mains electrical power and
whether the oven is connected
to the electricity supply.
Turn off the oven and restart it
to see if the fault persists.
XXXXXX XXXXX X XXXXX XXXXXXX
Model: xxxXXXXxx
XXXXX X
XXXX XX
XXXXXX
XXXXXXXXX