Publicidad
Idiomas disponibles
Idiomas disponibles
76
DEPTH LIMITER ADJUSTMENT
To obtain best performance and a correct advance of the motor
hoe, regulate the spur as indicated below (see figure 9):
a) Regulation for a hard terrain: loosen the screw (1) and lift the
spur so that the weight counteracts the weight of the motor
hoe.
b) Adjustment for soft floors: loosen the screw (1) and lower the
spur to move the weight of the motor hoe on the blades.
USING THE PRODUCT
TILLER CONTROLS
(1) Accelerator
(2) Clutch activation
(3) Selector switch
(4) Horizontal adjustment handlebar
(5) ON/OFF Switch
ACCELERATOR (1)
-
Left: minimum number of engine revolutions.
-
Right: maximum number of engine revolutions.
CLUTCH OPERATION (2)
Press the clutch drive to transfer the movement of the engine to the gearbox, remember to reduce the engine speed
before activating the clutch.
The clutch activation acts as a safety device during the use of the tool on reverse gear, do not use your tiller if this
device is damaged and/or does not operate correctly.
GEAR SELECTOR (3)
Method of use:
a) a) Using the accelerator, lower the engine speed until it is idling (1)
b) Position the gear selector (3) according to the type of work and condition of the terrain.
c) Increase the engine speed to an average speed using the accelerator (1)
d) Press the clutch activation (2) and increase the engine speed until it is suitable for the work to be performed.
e) To change gear, repeat steps a, b, c and d.
HORIZONTAL ADJUSTMENT OF THE HANDLEBAR (4)
Allows lateral orientation of the handlebar; unlocking the handlebar is done by turning the cam (4) counterclockwise
and clockwise to lock it in the desired position.
1
4
5
2
3
Publicidad
