Publicidad
Idiomas disponibles
Idiomas disponibles
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
• Place the bracket (3) of the rip fence on the
front guide profile (5).
• The rip fence can be moved along the guide
profile to any position and fixed with the
screw (6).
11.1.
Adjustment of rip fence
The rip fence must be adjusted so that it is
parallel to the saw blade. This can be achieved
by adjusting the guide profiles:
• Push the rip fence towards the saw blade.
• If the rip fence is not in exact contact with the
saw blade, first loosen the screws (1) on the
brackets.
• The guide profile is to be adjusted with the
adjusting screw (2).
• At the rear side, the adjusting screw (2) can be
screwed in or out further with an Allen key (3)
as required.
• Retighten the screws (1).
NOTE:
Use a wooden strip (with a length of
approx. 0.5m) which you can saw through in the
length.
• The difference, measured at the ends of the
wooden strip, has to be readjusted on the rip
fence guide profile.
12. Assembly mitre fence
• Insert the slot stone (2) of the mitre fence (1)
into the T-slot (3) on the work table.
• The mitre stop (1) can be moved along the T-
slot (3) on the work table and fixed in the
desired position with the star screw (4).
• The set angle can be read off the scale (5).
13. Assembly holder for the suction hose
The holder of the suction hose (2) can be moved
along the T-slot of the rear guide profile and is
installed as follows:
• Loosen the screw (1) that serves as a slot
stone, until it can be inserted into the T-slot
(3) of the rear guide profile.
• Retighten the screw (1) by turning the holder
(2).
ASSEMBLY
51
TS200 | TS250
Publicidad
