Descargar Imprimir esta página

HOLZMANN MASCHINEN TS200 230V Instrucciones De Servicio página 59

Publicidad

Idiomas disponibles

Idiomas disponibles

16.2.5
Checking / adjusting / replacing V-Belt
The V-belt tension is set correctly for new machines ex-factory. By stretching the belts over the
running time, retensioning of the V-belt is necessary.
Increase V-belt tension:
Loosen the 4 nuts (8) now the motor
can be shifted in the direction (+) of
more V-belt tension.
When correct tension is reached.
Tighten the 4 nuts (8) firmly again.
16.3
Storage
Improper storage can damage and destroy important machine parts. Store packed
or unpacked parts only under the intended ambient conditions!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORGE, DISPOSAL
Changing the belt:
• Dismount the saw blade and the riving.
• Remove the side cover (1) to gain access to the
belt. For this, disassemble the hand wheel (2) and
remove 4 screws (3) of the cover (1).
• Remove the suction hose (4) from the lower saw
blade guard (6).
• Remove the saw blade guard by loosening the 2
screws (5).
• By loosening the 2 nuts (8), the motor position can
be adjusted.
• Move the motor (7) upwards (-) to release the V-
belt (9).
• Now the V-belt can be changed.
• After changing the belt and adjusting the tension
correctly, reassemble the previously disassembled
components:
Lower saw blade guard
Suction hose
Saw blade
Riving knife + saw blade guard
Cover
• Then establish correct V-belt tension again.
Decrease V-belt-tension:
Loosen the 4 nuts (8) now the motor can be shifted
in the direction (-) of less V-belt tension.
When correct tension is reached. Tighten the 4 nuts
(8) firmly again.
N O TE
59
TS200 | TS250

Publicidad

loading

Este manual también es adecuado para:

Ts250 230vTs250 400v