Publicidad
Idiomas disponibles
Idiomas disponibles
Deviation of the supply voltage and frequency!
A deviation from the value of the supply voltage of ±5 % is permissible.
A short-circuit fuse must be provided in the power supply system of the machine!
Use a supply cable of type H07RN (WDE282) and take the required cross-section of the
•
supply cable from a current carrying capacity table. Pay attention to the measures for
protection against mechanical damage.
•
Make sure that the power supply is protected by a residual current circuit breaker.
•
Connect the device only to a properly grounded outlet.
When using an extension cable, make sure that the dimension matches the connected
•
load of the machine. The connection power can be found in the technical data, the
correlation of cable cross-section and cable lengths can be found in the technical
literature or obtain information from a specialist electrician.
A damaged cable must be replaced immediately.
•
14.5.1
Setting up a 400 V machine
•
The grounding conductor is yellow-green.
Connect the supply cable to the corresponding terminals in the input box (L1, L2, L3, N
•
and PE), see the figure below. If a CEE plug is available, the connection to the mains is
made through an appropriately powered CEE coupling (L1, L2, L3, N and PE).
Plug connection 400V:
After the electrical connection, check the correct running direction. If the machine runs
•
in the wrong direction, swap two conductive phases, egg. L1 and L2, at the connection
plug.
-
Operation is only permitted with residual current device (RCD) with maximum
residual current of 30 mA.
Immediately after making the electrical connection, check the running direction of the
blade. Observe the direction arrow on the machine. The running direction is correct if
the running direction of the blade corresponds to the direction of the direction arrow.
If this is not the case, swap two phases, e.g: L1 and L2, on the mains plug or on the phase
changing switch (if available).
14.6
Connecting to a dust collection system
The machine must be connected to dust collection system. The system must start up
at the same time as the motor of the band saw starts. For materials with a humidity <12
%, the air velocity at the dust collector port and in the hoses must be at least 20 m/s (for
moist chips with a humidity >12 %, at least 28 m/s). The suction hoses used must be
flame-retardant (DIN4102 B1), permanently antistatic (or grounded on both sides) and
comply with the relevant safety regulations. Requirements for the dust collection
system refer to the technical data.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
N O TE
5-wire:
with
N-conductor
N O TE
N O TE
N O TE
4-wire:
without
N-conductor
ASSEMBLY
53
TS200 | TS250
Publicidad
