Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE:
Never use products containing oil for cleaning, as these will attract dirt. This will cause the
saw blade to jam while machining a workpiece.
16.2.3
Assembly/exchange saw blade
16.2.4
Assembly / adjustment riving knife
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORGE, DISPOSAL
• Adjust the cutting height to the maximum possible level.
• Remove the saw blade guard (1) by slackening off the
locking knob (2) and unhooking from the riving knife.
• Loosen the two screws (3) that fix the table insert and
remove the table insert.
• Fix the drive shaft at the flange (6) with the supplied
flange wrench (4). For this purpose, the flange wrench
must be in line with the two flattened sides on the flange.
• Turn the screw (8) with a wrench (5) clockwise (left thread)
to loosen it.
• Remove the screw (8) with the washer (7), flange (6) and
saw blade (9) from the drive shaft.
• Clean the drive shaft and the flange (6) thoroughly from
impurities.
• Replace the old saw blade with a new one.
• Make sure that the new saw blade is undamaged and not
dirty.
• Place the saw blade (9) and the flange (6) on the drive
shaft.
• Screw the screw (8) with washer (7) back onto the drive
shaft, fix it (tightening torque: 25Nm
wrench (4) and tighten it counterclockwise with the
wrench (5).
NOTE
Retighten the nut tightly to prevent the nut from
loosening during operation.
• Replace the table insert and retighten the two screws (3)
to hold it in place.
• Fit the saw blade guard (1) on the riving knife.
The riving prevents the teeth on the rear circumference of
the saw blade from touching the workpiece and causing
unintentional damage or ejection.
• Loosen the two screws (1) that fix the table insert and
remove the table insert.
• Place a washer (4) on the thread of the screws (5), an outer
clamping plate (3) the riving knife (2) and the inner
clamping plate.
• Then, tighten the screws (5) slightly in the boreholes
provided.
• Adjust the distance between saw blade and riving knife.
NOTE:
The distance between the saw blade and the riving
knife must be within 3-8mm. This procedure should be
repeated each time the saw blade is replaced.
NOTE:
Check with the rip fence whether the riving knife is
parallel to the saw blade.
• Finally tighten (tightening torque: 25Nm
• Reinsert the table insert and fix it with 2 screws (1).
)
with the flange
)
the screws (4, 5).
58
TS200 | TS250
Publicidad
