Publicidad
Idiomas disponibles
Idiomas disponibles
16
CLEANING, MAINTENANCE, STORGE, DISPOSAL
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
Always disconnect the machine from the power supply before maintenance or
repair work and secure it against unintentional reconnection.
16.1
Cleaning
Wrong cleaning agents can attack the varnish of the machine. Do not use solvents, nitro
thinners, or other cleaning agents that could damage the machine's paint. Observe the
information and instructions of the cleaning agent manufacturer!
Regular cleaning is also a prerequisite for the safe operation of the machine and its long service
life. Therefore, clean the device after each use and remove dust and dirt. Use personal protective
equipment (gloves and eye protection or dust musk). Ensure that the saw blade protection is
free from wood residues and sawdust and make sure that you keep the table surface free of
resin.
16.2
Maintenance
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless,
malfunctions or defects which could impair the safety of the user must be rectified immediately!
•
Before each operation, check that the safety devices are in perfect condition.
•
Check the connections for a tight fit at least once a week.
•
Check regularly that the warning and safety signs on the machine are in good condition
and legible.
16.2.1
Maintenance schedule
The type and degree of machine wear depend on the operating conditions. The following
intervals apply when the machine is used within the specified limits:
interval
Before usage
machine
Before usage
machine
1 x month
V-Belt tension
1 x month
Moving parts
On demand
Saw blade
Before any manual tool change, stop the spindles, wait for standstill of all tools and
prevent an unintentional restart = unplug the power supply.
When handling circular saw blades when changing tools, please use safety gloves to
avoid risk of injury.
16.2.2
Cleaning the saw blade
Any deposition of resin on the teeth of the saw blade will cause the saw blade to jam during the
processing of a workpiece. For the purpose of maintenance, remove the saw blade from the drive
shaft and clean it with white spirit. After cleaning, the saw blade should be sprayed with silicone
spray.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
WAR N I N G
N O TE
components
Cleaning the machine
Removal of all loose parts / tools
Check and readjust belt tension if necessary.
Greasing / lubrication of guides / gear racks / wheels
Exchange saw blade if necessary
C AU TI O N
C AU TI O N
CLEANING, MAINTENANCE, STORGE, DISPOSAL
activity
57
TS200 | TS250
Publicidad
