Descargar Imprimir esta página

Dolmar AH1851 Manual De Instrucciones página 11

Cortasetos inalámbrico
Ocultar thumbs Ver también para AH1851:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 51
FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Installing or removing battery cartridge
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery car-
cartridge.
Fig.1: 1. Red indicator 2. Button 3.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
CAUTION:
Do not install the battery cartridge
forcibly.
Indicating the remaining battery capacity
Only for battery cartridges with the indicator
Fig.2: 1. Indicator lamps 2.
light up for a few seconds.
Indicator lamps
Lighted
Off
-
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
malfunctioned.
11 ENGLISH
NOTE: Depending on the conditions of use and the
Tool / battery protection system
Status
On
Overload
Overheat
Over
discharge
Overload protection
In this situation, turn the tool off and stop the application
the tool on to restart.
NOTICE:
Depending on the usage conditions,
the tool is automatically turned off without any
indication if the tool is overloaded by entangled
branches or debris. In this case, switch off the
tool and remove the battery cartridge, and then
remove entangled branches or debris using tools
such as pliers. After removing the branches or
debris, install the battery cartridge and turn on
the tool again.
Overheat protection for tool or battery
heating occurs,
tool on again.
Overdischarge protection
If the tool does not operate even when the switches are
Indicator lamps
Off
Blinking
-
-

Publicidad

loading

Este manual también es adecuado para:

Ah1860Ah1875